Making the 2015 Toted Infill Smoother Part 2

Join The Timetestedtools Forum!

Next task was to tune the drill press. I wanted to drill the holes straight throught the base, so the drill press needed to be perfect. I’ll be using 1/4″ brass rods for the pins on this infill



One of the harder parts to the build is sizing the metal to width. Using a 2″ iron, the inside measurment should be about 2 1/8″, so you’ll need to buy 2 1/2″ and size it down



Here is another task where a mill would be nice to have. I have this old portable tablesaw I stuck a cut off wheel in. Not ideal for the task, bit it got it done.

clip_image006          clip_image008

Part 1 Part 2 Part 3 Part 4 Part 5 Part 6 Part 7

<—–Previous —– Next—–>